Keysight Technologies J-BERT M8020A User Manual

Keysight M8070A Programming Guide 265
SCPI Command Reference 5
:N1000:EMODules:SLOT:CONNect[?]
Syntax :N1000:EMODules:SLOT:CONNect <identifier>,{ON | OFF | 1 | 0}
:N1000:EMODules:SLOT:CONNect? <identifier>
Input
Parameters
‘identifier’: ‘DCA*.SLOT*'
ON | OFF | 1 | 0
Return Range ON | OFF | 1 | 0
Description This command enables usage of the addressed slot by M8070A. In case of
using multiple M8070A instances, make sure to enable a slot only in
exactly one M8070A instance.
This query returns the present state.
This SCPI is applicable for M8046A.
Example :N1000:EMOD:SLOT:CONN "DCA1.SLOT1",ON
:N1000:CRECovery:ODRatio:AUT
O[?] on page 266
:N1000:CRECovery:ODRatio:AUTO[?] on
page 269
:N1000:CRECovery:RDIVider[?] :N1000:CRECovery:RDIVider[?] on page 269
:N1000:CRECovery:RELock :N1000:CRECovery:RELock on page 269
:N1000:CRECovery:SOURce[?] :N1000:CRECovery:SOURce[?] on page 270
Name Description under
NOTE
This command is not the same as the similar FlexDCA command
:EMODules:SLOT{n}:CONNect[?] {ON | OFF | 1 | 0}
The above command must be sent to FlexDCA prior starting up the
M8070A software instances that shall control FlexDCA!
Managing the slot usage and connection state must be done using the
FlexDCA commands or user interface before starting up M8070A.

Keysight Technologies J-BERT M8020A Specifications

General

Brand	Keysight Technologies
Model	J-BERT M8020A
Category	Control Unit
Language	English