486 Keysight M8070A Programming Guide
5 SCPI Command Reference
:DATA:SEQuence:GRANularity?
Syntax :DATA:SEQuence:GRANularity? <sequence-name>
Input
Parameters
<sequence-name>: Specify sequence name, i.e., ‘Sequence1’
Description This query returns the granularity in bits of sequence. It changes with the
symbol width. The following table shows the granularity for various symbol
widths for different modules:
Example :DATA:SEQ:GRAN? ‘Sequence1’
:DATA:SEQuence:GRANularity:IDENtifier?
Syntax :DATA:SEQuence:GRANularity:IDENtifier? <identifier>
Input
Parameters
<identifier>: 'M*.DataIn1', 'M*.DataIn2', 'M*.DataIn', 'M*.DataOut',
'M*.DataOut1' and 'M*.DataOut2'
Description This query returns the current granularity in bits of location or group. It
changes with the symbol width. Refer to the table shown in the command
:DATA:SEQuence:GRANularity:IDENtifier? on page 486
.
Example :DATA:SEQ:GRAN:IDEN? ‘M1.DataIn1’
Symbol Width Granularity
(M8041A, M8051A,
M8195A, M8196A)
Granularity
(M8061A, M8062A)
Granularity
(M8045A, M8046A)
1 64 128 512
10 80 160 Not supported
130 130 260 Not supported
132 132 264 Not supported
To Next Page
Loading...
