VTerm
Specifies the termination voltage when the DC output path is selected.
Fine Delay
Specifies the fine delay portion of the variable delay (see available Range).
Coarse Delay
Specifies the coarse delay portion of the variable delay. See available Range and
Resolution.
Carrier Scale
Sets the carrier amplitude scale for interpolated modes. The Carrier Scale refers to
the amplitude of the carrier signal in Up-Conversion Mode (Interpolated Mode).
IQ data is used to modulate the carrier signal. A filter is applied for interpolation
and this can depending on the IQ data values result in final DAC values, that are
outside the valid range of the DAC. The signal is then clipped and a warning
message is displayed in the Error List Window. When clipping is not acceptable,
the user can set a smaller carrier scale. The default value for carrier scale
guarantees in all cases a signal without clipping.
Carrier Frequency
Set the carrier frequency for interpolated modes.
Output enable switches
If set to closed position, the generated signal is present at the output.
To Next Page
Loading...
