Keysight M8190A - Page 7

Contents
M8190A User’s Guide 7
4 Digital Up-Conversion
4.1 Introduction 127
4.1.1 Direct Mode 128
4.1.2 Digital Up-Conversion Modes 129
4.1.3 Configuration at Run-Time 130
4.2 IQ Modulation 130
4.2.1 Interpolated Modes 130
4.2.2 Markers in Interpolated Modes 131
4.3 Configuration at Run-Time 131
4.3.1 Configuration using Standard Data Segments 132
4.3.2 Configuration using Configuration Segments 134
4.3.3 Sample-Aligned Configuration Using Markers 144
4.4 Amplitude Scaling 145
4.4.1 Scaling by using the amplitude table 145
4.4.2 Scaling by using the action table 146
4.4.3 Scaling by using the SCPI command or the Soft Front Panel 146
4.5 Coarse Delay and Digital Up-Conversion 147
4.6 Doublet Mode and Digital Up-Conversion 147
5 Streaming
5.1 Introduction 149
5.2 Streaming Implementation Using Dynamic Modes 149
5.3 Streaming Implementation Using the Ring Buffer Mechanism 150
5.3.1 Requirements 151
5.3.2 Theory of Operation 154
5.3.3 Examples 155
5.4 Memory Ping-Pong 157
5.4.1 Setup example using the SCPI API 157
6 Markers
6.1 Introduction 159
6.2 Sample Markers 159
6.2.1 Pause Between Multiple Marked Samples 161
6.2.2 Sample Marker in Looped Segments 161
6.2.3 Sample Marker in Segments which are Addressed Offset Based
161
6.3 Sync Markers 162
7 Low Phase Noise Operation
7.1 Introduction 163
7.2 Block Diagram 164
7.3 Operating in the Low Phase Noise Mode 165