Keysight M8190A - Page 82

2 M8190A User Interface
82 M8190A User’s Guide
 Action
The following actions and their corresponding parameters can be added to the
action IDs.
 PhaseOffset
This action allows setting an offset to the current phase. The phase offset
is a constant value added to the actual phase. It does not affect the NCO
counter itself. Therefore, the phase offset value could be set back to zero
again.
 PhaseBump
This action allows setting a phasebump value to the current phase. Phase
bump affects the NCO counter.
 PhaseReset
This action allows setting the phase to a specified absolute value.
 SweepRate
Sets the sweep rate to a specific value.
 SweepRestart
Stops a currently running frequency sweep and starts it again with the
start conditions of the previous sweep.
 SweepRun
Starts a frequency sweep.
 SweepHold
Stops a frequency sweep.
 CarrierFrequency
Sets the carrier frequency for interpolated modes.
 AmplitudeScale
Sets the carrier amplitude scale for interpolated modes.
 Parameter
Enter the relevant parameters’ values for the selected actions.
 (Add data)
Click this plus (+) icon to add a new action row.
 (Delete data)
Click this icon to delete selected action rows.
 Update Action Table at Runtime
If you modify the parameters of existing Action Table entries during run-time, use
this option to update the same with the instrument. The button is disabled if a new
Action Table entry/row is created or any of the field values, other than the
parameters, of existing entries/rows is changed.
Frequency Table
 # (Frequency ID)
Whenever a new frequency row is created, it is automatically allocated a numeric
ID termed as #. First frequency row has the # value as 1, second as 2, and so on.
 Frequency
Enter the required frequency value in the frequency row.
 (Add data)
Click this plus (+) icon to add a new frequency row.