Keysight N6705C - Page 312

Parameter Typical Return
0 - 0.255|MIN|MAX, *RST 0.020 <delay value>
Sets a delay protection of 0.1 seconds: OUTP:PROT:DEL 0.1, (@1)
l The operation of over-current protection is affected by the setting of the current protection delay
start event, which is specified by [SOURce:]CURRent:PROTection:DELay:STARt.
OUTPut:PROTection:OSCillation 0|OFF|1|ON, (@<chanlist>)
OUTPut:PROTection:OSCillation? (@<chanlist>)
Enables/Disables oscillation protection. If capacitive loads cause the output to oscillate on the default
or any of the other bandwidth settings, this protection function will detect the oscillation and latch the
output off.
Parameter Typical Return
0|OFF|1|ON, *RST OFF 0or1
Enables oscillation protection: OUTP:PROT:OSC ON, (@1)
OUTPut:PROTection:TEMPerature:MARGin? (@<chanlist>)
Returns the margin remaining before the over-temperature trips. The temperature margin is the
minimum difference between the internal temperature sensors and the over-temperature trip level.
The margin is returned in degrees Celsius.
Parameter Typical Return
(none) <margin value>
Returns the temperature margin: OUTP:PROT:TEMP:MARG? (@1)
OUTPut:PROTection:WDOG[:STATe] 0|OFF|1|ON
OUTPut:PROTection:WDOG[:STATe]?
Enables/disables the I/O watchdog timer. When enabled, the output will be disabled if there is no I/O
activity on any remote interface within the time period specified by OUTput:PROTection:WDOG:DELay.
The output is latched off but the programmed output state is not changed.
Parameter Typical Return
0|OFF|1|ON, *RST OFF 0or1
Enables the watchdog timer protection: OUTP:PROT:WDOG ON
7 SCPI Programming Reference
312 Keysight N6705C Operating and Service Guide