Keysight N9010B - Page 42

Table Of Contents
Adjust Range for Min Clipping 1437
Pre-Adjust for Min Clipping 1437
Peak-to-Average Ratio 1438
Mixer Lvl Offset 1439
3.9.13.4 Signal Path 1439
Presel Center 1439
Preselector Adjust 1441
Internal Preamp 1442
LNA 1443
µW Path Control 1445
Allow Full Bypass in Auto 1454
Software Preselection 1455
SW Preselection Type 1456
SW Preselection BW 1457
High Freq Prefilter 1458
3.9.14 BW 1459
3.9.14.1 Settings 1459
RBW Filter Type 1459
3.9.15 Display 1460
3.9.15.1 Meas Display 1460
Limit Lines 1460
3.9.15.2 Annotation 1461
Graticule 1461
Screen Annotation 1461
Trace Annotation 1462
Control Annotation 1462
Meas Bar 1463
Display Enable (Remote Command Only) 1463
3.9.15.3 View 1464
3.9.16 Frequency 1464
3.9.16.1 Settings 1465
Center Frequency 1465
CF Step 1470
3.9.17 Marker 1471
3.9.17.1 Select Marker 1471
3.9.17.2 Settings 1472
Marker Frequency 1472
Marker Mode 1473
All Markers Off 1474
Couple Markers 1474
3.9.17.3 Properties 1474
Marker Frequency 1474
42 Vector Modulation Analyzer Mode User's &Programmer's Reference