Keysight Truevolt Series User Manual

SYSTem:TIME <hour>, <minute>, <second>
SYSTem:TIME?
Sets the time for the instrument's real-time clock. Use SYSTem:DATE to set the date.
Parameter Typical Return
<hour> 0 to 23
<minute> 0 to 59
<second> 0 to 60
20,15,30.000
Set instrument time to 20:15:30 (8:15:30 PM):
SYST:TIME 20,15,30
l The real-time clock is used for Mass Memory (MMEMory) system file time stamps.
l The real-time clock is battery-backed and retains the date and time when power is off.
l The date and time are not affected by *RST or SYSTem:PRESet.
l The real-time clock does not adjust itself for time zone changes or daylight savings time. Be sure to set
the date and time when you first receive your instrument.
SYSTem:UPTime?
Returns the amount of time that the instrument has been running since the last power-on.
Parameter Typical Return
(none) +8,+2,+13,+50
Return time that the instrument has been running:
SYST:UPT?
l Typically used to verify that the instrument is warmed up sufficiently before calibration.
l The numbers returned indicate days, hours, minutes, and seconds, respectively.
SYSTem:VERSion?
Returns the version of SCPI (Standard Commands for Programmable Instruments) that the instrument
complies with. There is no front panel equivalent. See Introduction to the Introduction to the SCPI Lan-
guage for details.
Parameter Typical Return
(none) 1994.0
Return the SCPI version:
SYST:VERS?
Keysight Truevolt Series Operating and Service Guide
403
SCPI Programming Reference

Keysight Truevolt Series Specifications

General

Brand	Keysight
Model	Truevolt Series
Category	Measuring Instruments
Language	English