bizhub C350 Field Service Ver. 2.0 April 2004 Utility Mode
3-35
III
Adjustment/Setting
3.17.9 Center Staple Position
Functions • To adjust the positions of center staple and folding for the Finisher.
Use • Use when the center staple and folding positions deviate from the correct ones in the
copies made using the Booklet function.
Adjustment
Specification
• Center staple position:
The adjustment range is -7.0 mm to +7.0 mm (in 1-mm increments).
• Fold position:
The adjustment range is -7.0 mm to +7.0 mm (in 1-mm increments).
Adjustment
Instructions
If deviated to the left, increase the setting value.
If deviated to the right, decrease the setting value.
Adjustment
Procedure
1. Use the Booklet function to make one sample booklet.
2. Touch “Expert User Mode” → “Center Staple Position.”
3. Check the sample copy and make the necessary adjustment as detailed in the fol-
lowing.
Adjusting the center staple position:
4. If the staple positions deviate, use these steps to make the adjustment.
Adjusting the folding position:
5. If the folding position deviates, use these steps to make the adjustment.
6. Quit the Utility mode.
7. Using the Booklet function, make another sample booklet for confirmation.
8. Check the sample copy and repeat the adjustment procedures until there are no
deviations in the staple or folding position.
4036fs3011c
4036fs3012c0
If the staple positions deviate to the left side, increase the setting value.
If the staple positions deviate to the right side, decrease the setting value.
Deviated to left Deviated to right
4036fs3013c0
4036fs3014c0
If the folding position deviates to the left side, increase the setting value.
If the folding position deviates to the right side, decrease the setting value.
Deviated to left Deviated to right
FS3.fm Page 35 Tuesday, April 27, 2004 3:43 PM
To Next Page
Loading...
Need help?
General
