Kubota WSM 05-E4B Series - Removing Starter (Electromagnetic Drive Type)

11. Lightly secure the rotor with a vise to prevent damage, and remove the bearing (7) with a puller.
(1) Pulley
(2) Drive end frame
(3) Stator
(4)
Bearing
(5) Retainer plate
(6) Rotor
(7) Bearing
(8) Rear end frame
(9) Rectifier
(10) IC regulator
(11) Brush holder
(12) Rear end cover
(When reassembling)
• Tighten to the specified tightening torque.
T
ightening torque Pulley nut
58.4 to 78.9 N⋅m
5.95 to 8.05 kgf⋅m
43.1 to 58.2 lbf⋅ft
5.30 Removing starter (Electromagnetic drive type)
NOTE
• Do not damage to the brush and commutator.
1.
Remove the C terminal nut (7), and disconnect the connecting lead (12).
4. ENGINE
SERVICING
5. Disassembling and assembling
4-46
05-E4B SERIES,05-E4BG SERIES
KiSC issued 03, 2023 A