Kubota WSM 05-E4B Series User Manual

4. Replace
with
the
new upper / lower hose (1), (2)
and clamp bands.
(1) Upper hose (2) Lower hose
5. Tighten the clamp bands.
6. Fill with clean
water and anti-freeze until the coolant
level is just below the port. Install the radiator cap
securely.
13.4 Replacing fuel hoses and clamp
bands
CAUTION
• Stop the engine
when checking and changing
the fuel hose.
1. Loosen the clamp (2) and remove the fuel hose (1).
2. Replace with the
new fuel hose (1) and new clamp
(2).
3. Tighten the clamp (2).
(1) Fuel hose
(2) Clamp
[A] Cartridge type
[B]
Element type
(When bleeding fuel system)
NOTE
• Always keep the
air vent valve on the fuel
injection pump closed except when air is
vented, or it may cause the engine to stop.
1. Fill the tank with fuel and open the fuel valve (4).
2. Loosen the air vent plug (3) of the fuel filter a few
turns.
(3) Air vent plug
(4) Fuel valve
[A] Cartridge type
[B] Element type
3. Screw back the plug when bubbles do not come up
any more.
3. MAINTENANCE
CHECK AND MAINTENANCE
13. Check points of every 2 years
3-20
05-E4B SERIES,05-E4BG SERIES
KiSC issued 03, 2023 A

Kubota WSM 05-E4B Series Specifications

General

Brand	Kubota
Model	WSM 05-E4B Series
Category	Engine
Language	English