EasyManuals Logo

Kubota WSM 05-E4B Series User Manual

Kubota WSM 05-E4B Series
168 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #71 background imageLoading...
Page #71 background image
7. Fill
with coolant up to full (A) mark on the recovery
tank (3).
(3) Recovery tank
(A) Full
(B) Low
8.
Start and operate the engine for a few minutes.
9. Stop
the
engine
and let cool. Check coolant level of
radiator and recovery tank (3) and add coolant if
necessary.
Anti-freeze
IMPORTANT
Make sure that
when you mix the anti-freeze
and water, the ratio of anti-freeze is less than
50 %.
Ratio of
anti-
freeze
Freezing point Boiling point
*
40 % −24 −11 106 223
50 % −37 −35 108 226
* At
1.01
×
100000 Pa (760 mmHg) pressure
(atmospheric). Use a radiator pressure cap that lets
the pressure collect in the cooling system to get a
higher boiling point.
NOTE
The above data
is the industrial standards
that shows the minimum glycol content
necessary in the concentrated anti-freeze.
When the coolant level decreases because
of evaporation, add clean, soft water only to
keep the anti-freeze mixing ratio less than
50 %. If there is a leakage, add anti-freeze
and clean, soft water in the specified mixing
ratio.
The anti-freeze absorbs moisture. Keep new
anti-freeze in a tightly sealed container.
Do not use the radiator cleaning agents after
you add anti-freeze to the coolant. Anti-
freeze contains an anti-corrosive agent,
which reacts with the radiator cleaning
agent to make sludge and cause damages to
the engine parts.
(A) −0 (32 )
There
are 2 types of anti-freeze available: use
the permanent type (PT) for this engine.
When
you add anti-freeze for the first time, flush
the water jacket and radiator interior with clean,
soft water several times.
The brand of the anti-freeze and the ambient
temperature have an effect on the procedure to
mix water and anti-freeze. Refer to the SAE
J1034 standard, especially to the SAE J814c.
Mix the anti-freeze with clean, soft water, and
then fill into the radiator.
7.2 Replacing fan belt
1. Remove the alternator.
2. Remove the fan belt (1).
(1) Fan belt
3. Replace new fan belt.
4. Install the alternator.
 CHECK AND MAINTENANCE
7. Check points of every 500 hours 3. MAINTENANCE
05-E4B SERIES,05-E4BG SERIES
3-13
KiSC issued 03, 2023 A

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota WSM 05-E4B Series and is the answer not in the manual?

Kubota WSM 05-E4B Series Specifications

General IconGeneral
BrandKubota
ModelWSM 05-E4B Series
CategoryEngine
LanguageEnglish

Related product manuals