Kubota WSM 05-E4B Series - Handling Wire Harness

8. Handling wire harness
CAUTION
• Do not let
an unprotected wire harness to come
in contact with other components.
• Do not clamp the wire harness to fuel hoses.
• If the wire harness is damaged, replace it
immediately with a new one.
• Do not alter the electrical device and wire
harness.
• Tighten the electrical terminals securely.
(A) Good (B) Bad: Loose bolt
• Check the electrical terminal protection and
clamping conditions before connecting the battery
cable.
(C) Covered completely with a
protection cover
• Keep
the wire harness away from hazardous
positions such
as rotating parts or high-temperature
sections.
(D) Hazardous position
(E) Wiring position: bad
(F) Wiring position: good
(G)
Hazardous position
• If
wire harness is damaged or degraded, replace
immediately
.
(H) Damaged (I) Torn
• Install the grommet securely.
(1) Grommet
(J) Good
(K) Bad: poor installation
•
Clamp the wire harness securely. Do not damage
the wire harness by the clamp.
• Clamp
the wire harness correctly. Do not slack,
twist, and pull.
2. GENERAL
GENERAL WORKING PRECAUTIONS
8. Handling wire harness
2-4
05-E4B SERIES,05-E4BG SERIES
KiSC issued 03, 2023 A