(When reassembling)
•
Apply grease (DENSO.CO.L
TD. No. 50 or equivalent) to the parts indicated in the figure.
–
Joint of solenoid switch (a)
– Bushing (b)
– Drive lever (c)
– Collar (d)
– Teeth of pinion gear (e)
– Armature shaft (f)
• Tighten to the specified tightening torque.
Tightening torque B terminal nut
5.88 to 11.8 N⋅m
0.600 to 1.20 kgf⋅m
4.34 to 8.70 lbf⋅ft
5.31 Removing starter (Gear reduction type)
NOTE
• Do not damage to the brush and commutator.
1.
Remove the C terminal nut (3), and disconnect the connecting lead.
2. Remove the two through bolts (1).
3. Remove the motor.
4. Remove the end frame (8).
5. Remove the brush from the brush holder while holding the spring up.
6. Remove the brush holder (9).
7. Draw out the armature (5) from the yoke (4).
8. Remove the housing (13).
9. Remove the idle gear (7) and the overrunning clutch (6).
10. Remove the magnet switch cover (10).
4. ENGINE
SERVICING
5. Disassembling and assembling
05-E4B SERIES,05-E4BG SERIES
To Next Page
Loading...
