2KL/2KK
1-3-31
U093
Setting the exposure density gradient
Description
Changes the exposure density gradient in the manual density mode, depending on respective image quality
modes.
Purpose
To set how the image density is altered by a change of one step in the manual density adjustment for respec-
tive image quality modes. Also used to make copy images darker or lighter.
Method
1. Press the start key.
2. Select the image mode to be adjusted using the image mode selection key.
: Off, : On
Setting
1. Select the item to be set using the exposure adjustment keys.
2. Adjust the setting using the zoom +/- keys.
Increasing the setting makes the change in density larger, and decreasing it makes the change smaller.
Figure 1-3-15
3. Press the start key. The value is set.
Supplement
While this maintenance item is being executed, copying from an original is available in interrupt copying mode
(which is activated by pressing the interrupt key).
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Image mode LEDs Description
Density in text mode
Density in text and photo mode
Density in photo mode
Exposure
indicator
Description
Setting
range
Initial
setting
Exp. 1 Change in density when manual density is set dark 0 to 3 0
Exp. 2 Change in density when manual density is set light 0 to 3 0
Image density
Density adjustment
Dark
Light
Light
Center
Dark
Density adjustment range: Special area
Setting: 0Setting: 3
Density adjustment range: Normal
Set to DARKERSet to LIGHTER
To Next Page
Loading...
