Kyocera TASKalfa 220 - Maintenance Mode Item List

2KL/2KK-1
1-3-2
(2) Maintenance mode item list
Section
Item
No.
Content of maintenance item
Initial
setting*
General U000 Outputting an own-status report -
U001 Exiting the maintenance mode -
U002 Setting the factory default data -
U004 Checking the machine number -
U005 Copying without paper -
U019 Displaying the ROM version -
Initialization U020 Initializing all data -
U021 Initializing memories -
Drive, paper
feed and
paper convey-
ing system
U030 Checking motor operation -
U031 Checking switches for paper conveying -
U032 Checking clutch operation -
U034 Adjusting the print start timing
Adjusting the leading edge registration
Adjusting the center line
Adjusting the trailing edge margin
Adjusting the leading edge registration
2.8/0.0/0.0/0.0/0.0/0.8
*1
-2.4/0.0/0.0/0.0/0.0/0.0
*1
2.0
*1
2.0/2.0/2.0/2.0/2.0/2.0
*1
U035 Setting folio size
Length/Width 330/210
*1
U051 Adjusting the deflection in the paper 30/20/ 0/ -20/ -20/20
*1
U053 Performing fine adjustment of the motor speed 0.4/0.6/-0.5/0/0/0/0.5
*1
-0.1/-0.2/-0.3
*1
Optical U060 Adjusting the scanner input properties 12
*1
U061 Turning the exposure lamp on -
U063 Adjusting the shading position 0
*1
U065 Adjusting the scanner magnification
Main scanning direction
Auxiliary scanning direction
0
-10
*1
U066 Adjusting the scanner leading edge registration 0
*1
U067 Adjusting the scanner center line -10
*1
U068 Adjusting the scanning position for originals from the DP 0
*1
U070 Adjusting the DP magnification 0/0
*1
U071 Adjusting the DP scanning timing 0/0/0/0
*1
U072 Adjusting the DP center line 0/0
*1
U073 Checking scanner operation -
U074 Adjusting the DP input light luminosity 1
*1
U076 Adjusting the DP automatically -
U087 Setting DP reading position modification operation ON/35
*1
U088 Setting the input filter (moire reduction mode) Off
*1
U089 Outputting a MIP-PG pattern -
U092 Adjusting the scanner automatically -
U093 Setting the exposure density gradient
Text/text and photo/photo mode 0/0/0
*1
U099 Adjusting original size detection 170/30/240
*1
*Initial setting for executing U020, *1: The item initialized for executing U020, *2: The item initialized for executing U021