Kyocera TASKalfa 220 - Page 41

2KL/2KK-1
1-3-3
High voltage U100 Setting the main high voltage
Grid control voltage
Copy interval
Copy quantity
Correction amount
107
*1
60
*1
50
*1
10
*1
U101 Setting the other high voltages 27/45/22/45/123/126/33/31
*1
1/20/42/2
*1
U110 Checking the drum count -
Developing U130 Initial setting for the developing unit -
U144 Setting toner loading operation Off/5/30
*1
U150 Checking sensors for toner -
U157 Checking/clearing the developing drive time -
U158 Checking the developing count -
Fuser and
cleaning
U161 Setting the fuser control temperature
Primary stabilization fuser temperature
Secondary stabilization fuser temperature
Copying operation temperature 1
Copying operation temperature 2
Number of sheets for fuser control
Number of sheets for fuser control (thick paper)
145
*1
165
*1
175
*1
185
*1
1
*1
2
*1
U162 Stabilizing fuser forcibly -
U163 Resetting the fuser problem data -
U167 Checking the fuser count -
U198 Setting the fuser phase control Off
*1,*2
U199 Checking the fuser temperature -
Operation
panel and
support
equipment
U200 Turning all LEDs on -
U203 Checking DP separately -
U204 Setting the presence or absence of a key card or key counter Off
*1
U207 Checking the operation panel keys -
U243 Checking the operation of the DP motors -
U244 Checking the DP switches -
U245 Checking messages -
Mode setting U250 Setting the maintenance cycle 150000
*1,*2
U251 Checking/clearing the maintenance count 0
*1,*2
U252 Setting the destination Japan
*1
U253 Switching between double and single counts A3
*1,*2
U254 Turning auto start function on/off On
*1,*2
U260 Selecting the timing for copy counting After ejection
*1,*2
U265 Setting the destination specifications 0
*1
U277 Setting auto application change time 30
*1,*2
U285 Setting service status page On
*1,
U286 Setting the optional language 0
*1,*2
U332 Setting the size conversion factor 1.0
*1,*2
U341 Specific paper feed location setting for printing function -
U342 Setting the ejection restriction On
*1,*2
Section
Item
No.
Content of maintenance item
Initial
setting*
*Initial setting for executing U020, *1: The item initialized for executing U020, *2: The item initialized for executing U021