Kyocera TASKalfa 2550ci - Page 450

2MV-C
2-3-15
YC9
56 WTCFULLOU
T
O 0/3.3 V DC WTDS: On/Off
Connected to
engine con-
nect PWB
57 IDCLHP I 0/3.3 V DC IDS: On/Off
58 3.3V0 O 3.3 V DC 3.3 V DC power output to ECPWB
59 3.3V4 O 3.3 V DC 3.3 V DC power output to ECPWB
60 3.3V4 O 3.3 V DC 3.3 V DC power output to ECPWB
YC10
1 IDMOTA O 24 V DC IDSM: On/Off
Connected to
engine con-
nect PWB
2 IDMOTB O 24 V DC IDSM: On/Off
3 BLTREMA O 24 V DC TCBRM: On/Off
4 BLTREMB O 24 V DC TCBRM: On/Off
YC11
1 3.3V4 O 3.3 V DC 3.3 V DC power output to RFPWB
Connected to
RFID PWB
2 RFID_SCL O 0/3.3 V DC (pulse) RFPWB EEPROM clock signal
3 RFID_SDA I/O 0/3.3 V DC (pulse) RFPWB EEPROM data signal
4 GND - - GROUND
YC12
B1 LSUMOTB O 0/24 V DC LSUCM: Forward/Stop (Forward)
Connected to
LSU connect
PWB
B2 LSUMOTA O 0/24 V DC LSUCM: Forward/Stop (Reverse)
B3 MP(K)_REM O 0/3.3 V DC PM: On/Off
B4 24V4 O 24 V DC 24 V DC power output to PM
B5 MP(K)_RDY I 0/3.3 V DC PM ready signal
B6 MP(M)_REM O 0/3.3 V DC PM: On/Off
B7 MP(C)_REM O 0/3.3 V DC PM: On/Off
B8 MP(C)_RDY I 0/3.3 V DC PM ready signal
B9 VCONT(K) O Analog APCPWB laser power standard voltage
B10 MP(Y)_RDY I 0/3.3 V DC PM ready signal
B11 VCONT(M) O Analog APCPWB laser power standard voltage
B12 LSU_TH(Y) I Analog LSU thermistor signal
B13 VCONT(Y) O Analog APCPWB laser power standard voltage
B14 GND - - GROUND
B15 VCONT(C) O Analog APCPWB laser power standard voltage
A1 3.3VIL O 3.3 V DC 3.3 V DC power output to BDPWB
A2 GND - - GROUND
A3 LSU_TH(K) I Analog LSU thermistor signal
A4 EN(K) O 0/3.3 V DC APCPWB laser enable signal
A5 EN?COL) O 0/3.3 V DC APCPWB laser enable signal
A6 MP(Y)_CLK O 0/3.3 V DC (pulse) PM clock signal
A7 MP(Y)_REM O 0/3.3 V DC PM: On/Off
Connector Pin Signal I/O Voltage Description