Kyocera TASKalfa 2550ci - Page 46

2MV
1-2-22
10. Remove four wire holders.
11. Remove two connector (YC1 and
YC27) from the main PWB.
12. Remove two screws and then remove
the hard disk.
* : Be careful not to give excessive vibra-
tion and shock to a hard disk for break-
age prevention.
Figure 1-2-28
13. Attaches four wire saddle to the
controller box and four wire saddle to
the IH box cover.
Then release the hook of all wire
saddles.
14. Release the hook of wire saddle A
(standard).
Figure 1-2-29
Screw
Screw
Wire holder
Wire holder
Wire holder
Wire holder
Connector (YC27)
Connector (YC1)
Hard disk
Wire saddle A (standard)
Wire saddles A
Wire saddles A
Controller box
IH box cover