Kyocera TASKalfa 2550ci - Page 463

2MV
2-3-28
YC7
1 3.3V4 O 3.3 V DC 3.3 V DC power output to PS3
Connected to
paper sen-
sor 3, paper
sensor 4, lift
sensor 2
2 GND - - GROUND
3 PAPEMP3 I
0/3.3 V DC
PS3: On/Off
4 3.3V4 O 3.3 V DC 3.3 V DC power output to PS4
5 GND - - GROUND
6 PAPEMP4 I
0/3.3 V DC
PS4: On/Off
7 3.3V4 O 3.3 V DC 3.3 V DC power output to LS2
8 GND - - GROUND
9 LIFTFULL2 I
0/3.3 V DC
LS2: On/Off
YC8
1 GND - - GROUND
Connected to
lift motor 2,
feed sensor
2, right cover
2
2 BO2_REM O 0/3.3 V DC LM2: On/Off
3 3.3V4 O 3.3 V DC 3.3 V DC power output to LS2
4 GND - - GROUND
5 FEEDSW2 I 0/3.3 V DC FS2: On/Off
6RIGHT
COVER SET
I 0/3.3 V DC RCSW2: On/Off
7 GND - - GROUND
YC9
1 24V4 O 24 V DC 24 V DC power output to the coin vender
Connected to
coin vender
2 SGND - - GROUND
3 SGND - - GROUND
4 MCV_ENBL I 0/3.3 V DC Coin vender enable signal
5 FGND - - GROUND
6 MCV_FED_C
OUNT
O 0/3.3 V DC Coin vender control signal
7MCV_EJ_CO
UNT
O 0/3.3 V DC Coin vender control signal
8MCV_COPY_
SIG
O 0/3.3 V DC Coin vender control signal
9MCV_UART_
TXD
O 0/3.3 V DC (pulse) Serial communication data signal output
10 SGND - - GROUND
11 MCV_UART_
RXD
I 0/3.3 V DC (pulse) MCV: On/Off
12 SGND - - GROUND
YC13
1 RESET0 O 0/3.3 V DC Reset signal
Connected to
main PWB
2 WAKEUP0 I 0/3.3 V DC Control signal
3 AUDIO0 O Analog AUDIO signal
4 GND - - GROUND
5 USB_DP0 I/O - USB data signal
Connector Pin Signal I/O Voltage Description