Kyocera TASKalfa 2550ci - Page 54

2MV
1-2-30
6. Remove two screws and then remove
the ISU right cover.
7. Remove the right upper cover.
Figure 1-2-39
8. Cut out four ribs of the aperture plate
(left side) on the right upper cover using
nippers.
Note: Cut off the rib (lower part)
certainly so that a projection does not
remain.
Figure 1-2-40
Right upper
cover
Screw
ISU right cover
Right upper cover
Aperture
Ribs
Rib (lower part)