Kyocera TASKalfa 2550ci - Page 55

2MV
1-2-31
9. Remove fifteen screws and then
remove the controller box cover.
Figure 1-2-41
10. Remove four wire holders.
11. Remove two connector (YC1 and
YC27) from the main PWB.
12. Remove two screws and then remove
the hard disk.
Caution: Be careful not to give exces-
sive vibration and shock to a hard disk
for breakage prevention.
Figure 1-2-42
Screw
Screw
Screw
Screw
Screw
Screw
Screw
Screw
Screw
Screws
Screws
Screw
Screw
Controller box
cover
Screw
Screw
Wire holder
Wire holder
Wire holder
Wire holder
Connector (YC27)
Connector (YC1)
Hard disk