2KR/2KS
1-3-67
U245
Checking messages
Description
Displays a list of messages on the touch panel of the operation panel.
Purpose
To check the messages to be displayed.
Method
1. Press the start key.
2. Select the item to be displayed.
3. Displays the message one by one using cursor up/down keys. Switches the language on the touch
panel using the cursor +/- keys.
When a message number is entered with the numeric keys and then the start key is pressed, the mes-
sage corresponding the specified number is displayed.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
U246
Setting the finisher
Description
Provides various settings for the 3000-sheet document finisher, if furnished.
Purpose
Adjustment of registration stop timing in punch mode
Adjust if skewed paper conveying occurs or if the copy paper is Z-folded in punch mode.
Adjustment of paper stop timing in the punch mode
To adjust this item when the position of a punch hole is different from the specified one.
Adjustment of front/rear side registration home position of Inner tray
Provides optimization when paper jam occurs due to an inferior fitting of the Inner tray adjuster guides to
paper.
Adjusting of front and back/slanted stapling home position
Adjusts the stapling position in the staple mode if the position is not proper.
Provides adjustment of slanted stapling.
Adjustment of upper/lower side registration home position of center-folding unit
Provides optimization when paper jam occurs due to an inferior fitting of the centerfold adjuster guides to paper.
Adjustment of booklet stapling position
Adjusts the booklet stapling position in the stitching mode if the position is not proper.
Adjustment of center folding position
Adjusts the center folding position in the stitching mode if the position is not proper.
Method
1. Press the start key.
2. Select the item to be set. The screen for setting each item is displayed.
Setting: [FINISHER 3000]
1. Select the item to set. The screen for setting each item is displayed.
Maintenance
item No.
Description
Display Description
FINISHER 3000 Adjustment of the 3000-sheet document finisher
BOOKLET FOLDER Adjustment of the centerfold unit
FINISHER B’-IN Adjustment of the built-in finisher
Display Description
PUNCH REG ADJ Adjustment of registration stop timing in punch mode
PUNCH POSITION ADJ Adjustment of the paper stop timing in punch mode
WIDTH F HP ADJ Adjustment of front side registration home position
WIDTH R HP ADJ Adjustment of rear side registration home position
STAPLE HP ADJ Adjustment of front and back stapling home position
TURNED STAPLE HP ADJ Adjustment of slanted stapling home position
To Next Page
Loading...
