Kyocera TASKalfa 420i - Detaching and Refitting the Fuser Thermistor 1 and 2

2KR/2KS
1-5-35
(6) Detaching and refitting the fuser thermistor 1 and 2
Follow the procedure below to replace the fuser thermistor 1 and 2.
Procedure
1. Remove the fuser unit (see page 1-5-30).
2. Remove the upper fuser cover (see page 1-
5-31).
3. Release the stopper of the fuser thermistor
2.
4. Remove the connector and remove the
fuser thermistor 2.
5. Replace the fuser thermistor 2 and install
the thermistor to fuser unit.
Figure 1-5-70
6. Remove the press roller and fuser heater
(see page 1-5-32 and 1-5-33).
7. Remove the heat roller (see page 1-5-34).
8. Remove the screw and the connector, and
then remove the fuser thermistor 1.
9. Replace the fuser thermistor 1 and install
the thermistor to fuser unit.
10. Refit the heat roller, fuser heater, press roller
and upper fuser cover.
11. Refit the fuser unit.
Figure 1-5-71
Connector
Fuser thermistor 2
Stopper
Connecto
r
Screw
Fuser thermistor 1