2KR/2KS-1
1-3-60
U234
Setting punch destination
Description
Sets the destination of punch unit of 3000-sheet document finisher.
Purpose
To be set when installing a different punch unit from the destination of the machine.
Setting
1. Press the start key.
2. Select the destination.
Initial setting: AUTO
3. Press the start key. The setting is set.
4. Turn the main power switch off and on.
U236
Setting the limit for the ejection section of the built-in finisher
Description
If the machine is equipped with an built-in finisher, this mode sets whether A5R/B5R/statement size paper is
output to the machine top tray or not.
Purpose
If the machine is equipped with an built-in finisher and if paper jams occur due to curling of paper in the built-
in ejection section when two-sided copying onto A5R/B5R/statement size paper is performed, this mode is
used to change the setting to ON to disable ejection to the machine top tray.
Setting
1. Press the start key.
2. Select ON or OFF.
Initial setting: OFF
3. Press the start key. The setting is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description
AUTO With no punch unit
JAPAN METRIC Metric (Japan) specifications
INCH Inch (North America) specifications
EUROPE METRIC Metric (Europe) specifications
Display Description
ON Does not eject to the machine top tray.
OFF Eject to the machine top tray.
To Next Page
Loading...
