2KR/2KS
1-3-117
RA (Stateless) Settings
1. Press [Next] of Network and then [Next] of TCP/IP
Setting.
2. Press [Next] of IPv6.
3. Press [Change] of RA(Stateless).
4. Press [On] or [Off] of RA (Stateless).
5. Press [OK].
6. After changing the setting, restart the system or
turn the machine OFF and then ON again.
DHCP (IPv6) Settings
1. Press [Next] of Network and then [Next] of TCP/IP
Setting.
2. Press [Next] of IPv6.
3. Press [Change] of DHCP.
4. Press [On] or [Off] of DHCP.
5. Press [OK].
6. After changing the setting, restart the system or
turn the machine OFF and then ON again.
NetWare Setup
1. Press [Next] of Network and then [Change] of Net-
Ware.
2. Press [On].
3. Press the key for the frame type you want to use.
4. Press [OK].
5. After changing the setting, restart the system or
turn the machine OFF and then ON again.
AppleTalk Setup
1. Press [Next] of Network and then [Change] of
AppleTalk.
2. Press [On] or [Off].
3. Press [OK].
4. After changing the setting, restart the system or
turn the machine OFF and then ON again.
WSD Scan Setup
1. Press [Next] of Network and then [Change] of WSD
Scan.
2. Press [On] or [Off].
3. Press [OK].
4. After changing the setting, restart the system or
turn the machine OFF and then ON again.
WSD Print Setup
1. Press [Next] of Network and then [Change] of WSD
Print.
2. Press [On] or [Off].
3. Press [OK].
4. After changing the setting, restart the system or
turn the machine OFF and then ON again.
SSL Setup
1. Press [Next] of Network, [Next] of Secure Protocol,
and then [Next] of SSL.
2. Press [On] or [Off].
3. Press [OK].
4. After changing the setting, restart the system or
turn the machine OFF and then ON again.
IPP Security Setup
1. Press [Next] of Network, [Next] of Secure Protocol,
and then [Change] of IPP Security.
2. Press [IPP over SSL Only] or [IPP or IPP over
SSL].
3. Press [OK].
4. After changing the setting, restart the system or
turn the machine OFF and then ON again.
HTTP Security Setup
1. Press [Next] of Network, [Next] of Secure Protocol,
and then [Change] of HTTPS Security.
2. Press [HTTP or HTTPS] or [HTTPS Only].
3. Press [OK].
4. After changing the setting, restart the system or
turn the machine OFF and then ON again.
LDAP Security Setup
1. Press [Next] of Network, [Next] of Secure Protocol,
and then [Change] of LDAP Security.
2. Press [Off], [LDAP over SSL] or [LDAPv3/TLS].
3. Press [OK].
4. After changing the setting, restart the system or
turn the machine OFF and then ON again.
IPSec Setting
1. Press [Next] of Network, and then [Change] of
IPSec.
2. Press [On].
3. Press [OK].
4. After changing the setting, restart the system or
turn the machine OFF and then ON again.
LAN Interface Setup
1. Press [Next] of Network and then [Change] of LAN
Interface.
2. Select [Auto], [10BASE-T Half], [10BASE-T Full],
[100BASE-TX Half] or [100BASE-TX Full] as the
LAN interface.
3. Press [OK].
4. After changing the setting, restart the system or
turn the machine OFF and then ON again.
To Next Page
Loading...
