LEGRAND PDU - Page 146

June 2018
146 Legrand PDU User Guide
 DHCP settings: Optionally specify the preferred hostname, which must meet the following requirements:
 Consists of alphanumeric characters and/or hyphens
 Cannot begin or end with a hyphen
 Cannot contain more than 63 characters
 Cannot contain punctuation marks, spaces, and other symbols
 Static settings: Assign a static IPv4 address, which follows this syntax "IP address/prefix length".
Example: 192.168.84.99/24
 IPv6 settings:
Field/setting Description
Enable IPv6 Enable or disable the IPv6 protocol.
IP Auto
Configuration
Select the method to configure IPv6 settings.
 Automatic: Auto-configure IPv6 settings via
DHCPv6.
 Static: Manually configure the IPv6 settings.
 Automatic settings: Optionally specify the preferred hostname, which must meet the above
requirements.
 Static settings: Assign a static IPv6 address, which follows this syntax "IP address/prefix length".
Example: fd07:2fa:6cff:1111::0/128
 (Optional) To view the wireless LAN diagnostic log:
 Click Show WLAN Diagnostic Log. See Wireless LAN Diagnostic Log (on page 146).
Wireless LAN Diagnostic Log
The Legrand PDU provides a diagnostic log for inspecting connection errors that occurred over the wireless
network interface. The information is useful for technical support.
Note that the WLAN Diagnostic Log shows data only after the Network Interface is set to Wireless.
Each entry in the log consists of:
 ID number
 Date and time
 Description
 To view the log:
1. Choose Device Settings > Network > WIRELESS > Show WLAN Diagnostic Log. See Configuring
Network Settings (on page 140).
2. The log is
refreshed automatically at a regular interval of five seconds. To avoid any new events'
interruption during data browsing, you can suspend the automatic update by clicking
.