LEGRAND PDU - Page 325

June 2018
Legrand PDU User Guide 325
config:# security ipAccessControl ipv6 ru
l
e add <direction> <insert> <rule_number>
<ip_mask> <policy>
Variables:
 <direction> is one of the options: in or out.
Direction Description
in Inbound traffic.
out Outbound traffic.
 <ip_mask> is the combination of the IP address and subnet mask values (or prefix length), which are
separated with a slash. For example, an IPv4 combination looks like this: 192.168.94.222/24.
 <policy> is one of the options: accept, drop or reject.
Policy Description
accept Accepts traffic from/to the specified IP
address(es).
drop Discards traffic from/to the specified IP
address(es), without sending any failure
notification to the source or destination host.
reject Discards traffic from/to the specified IP
address(es), and an ICMP message is sent to the
source or destination host for failure notification.
 <insert> is one of the options: insertAbove or insertBelow.
Option Description
insertAbove Inserts the new rule above the specified rule
number. Then:
new rule's number = the specified rule number
insertBelow Inserts the new rule below the specified rule
number. Then:
new rule's number = the specified rule number + 1
 <rule_number> is the number of the existing rule which you want to insert the new rule above or below.
Modifying a Firewall Rule
Depending on what to modify in an existing rule, the command varies.
 IPv4 commands
 Modify an IPv4 rule's IP address and/or subnet mask:
config:# security ipAccessControl ipv4 rule modify <direction> <rule_number> ipMask
<ip_mask>
 Modify an IPv4 rule's policy: