LEGRAND PDU - Page 489

June 2018
Legrand PDU User Guide 489
To set or
enable
Use this command
EAP CA
certificate
network wireless
eapCACertificate
When prompted to enter the CA
certificate, open the certificate with a
text editor, copy and paste the content
into the communications program.
The content to be copied from the CA certificate does NOT include the first line containing "BEGIN
CERTIFICATE" and the final line containing "END CERTIFICATE." If a certificate is installed, configure the
following:
Whether to Use this command
Verify the
certificate
network wireless
enableCertVerification
<option1>
<option1> = true or false
Accept an
expired or not
valid
certificate
network wireless
allowOffTimeRangeCerts
<option2>
<option2> = true or false
Make the
connection
successful by
ignoring the
"incorrect"
system time
network wireless
allowConnectionWithIncorrectC
lock <option3>
<option3> = true or false
 Wireless IPv4 / IPv6 settings:
Commands for wireless IP settings are identical to those for wired networking. Just replace the variable
<ETH> with the word 'wireless'. The following illustrates a few examples.
To set or
enable
Use this command
IPv4
configuration
method
network ipv4 interface WIRELESS
configMethod <mode>
<mode> = dhcp (default) or static
IPv6
configuration
method
network ipv6 interface WIRELESS
configMethod <mode>
<mode> = automatic (default) or static
 To verify network settings:
After exiting the above configuration mode and the # prompt re-appears, type this command to verify all
network settings.
 show network
The IP address configured may take seconds to take effect.