Lenze 8600 series - Page 6

6 Accessories 38
6.1 Brake resistors
6.1 .l Selection of the brake resistor
6.1.2 Technical data of brake resistors
6.2 Mains Chokes
6.2.1 Selection of the mains Choke
6.2.2 Technical data of mains Chokes
6.3 Motorfilter
6.3.1 Technical data of motor filters
6.4 Sine filter
6.4.1 Technical data of sine filters
6.5 Gable protection
6.6 RFI filters
6.6.1 Ratings of RFI filters
6.6.2 Technical data of RFI filters
6.7 Accessories for digital frequency networking
38
39 -
41
42
43
44
45
46
47
48
49
50
50
51
51
7 Accessories for networking
52
7.1 Connecting module 211 OIB- InterBus-S
52
7.2 Connecting module 2130lB- PROFIBUS
52
7.3 Connecting elements for Optical fibre cables-LECOM-LI 53 -
7.4 Level converter 2101 IP- LECOM-NB
53
7.5 Adapter FIS485 (LECOM interface X6)
53
8 Initial switch-on
54
Parameter setting
1 Keypad
1.1 Key functions
1.2 Plain text display
2 Basic Parameter setting
2.1 Changing Parameters
2.1 .l Parameter setting by two Codes
2.2 Save Parameters
2.3 Load Parameters
3 Basic settings
3.1 Operating mode
3.1 .I Controller enable
3.1.2 Quick stop / Select direction of rotation
3.2 Configuration
3.2.1 Example of how to select a configuration
3.3 Signal-flow Chart for Speed-controlled Operation
(CO05 = -o- to -15)
3.4 Features of setpoint 1
3.4.1 Setpoint input with master current
3.4.2 Digital frequency input
3.5 Features of setpoint 2
3.6 Offset and gain adjustment
3.7 Control mode
3.7.1 V/f-characteristic control
3.7.2 Io control
3.8 Minimum field frequency fdmin
3.9 Maximum field frequency fdmax
3.10 Acceleration and deceleration times Tir, Tif
55
55
55
56
56
58
58
58
59
59 -
60
60
62
63
64
66
66
69
68
68
69
70
72
73
73
74
4
lenze