Lenze 8600 series - Page 7

4 Closed-loop speed control
75
4.1 Analog act. value
75
4.2 Digital act. value
75
4.3 Frequency Pilot control
76
4.4 Adjustment of the act. value gain
78
4.4.1 Automatic adjustment
78
4.4.2 Manual adjustment
78
4.5 Setting of the controller Parameters 79
4.6 Additional functions
80
5 Programming of the freely assignable inputs and Outputs
81
5.1 Freely assignable digital inputs
5.2 Functions of the freely assignable digital inputs
5.2.1 Set TRIP
52.2 Reset TRIP
5.2.3 DC-injection brake
5.2.4 JOG frequencies
5.2.5 Additional acceleration and deceleration times
5.2.6 Ramp generator stop
5.2.7 Ramp generator input = 0
5.2.8 Integral action component = 0
5.2.10 Reset 1-component / D-component - dancer-Position controller
52.11 Suppression of the dancer-Position controller
5.2.12 Reset of the Sensor compensation
5.3 Freely assignable digital Outputs, relay output
5.4 Functions of the freely assignable digital Outputs
5.4.1 Frequency below a certain threshold, Qmin
5.4.2 Maximum current reached, Imax
5.4.3 Setpoint reached, RFG/O=I
5.4.4 Fault indication TRIP
54.5 Ready, RDY
81
82
82
82
83
84
86
88
88
88
90
90
90
90
91
91
92
92
92
92
92
93
93
94
95
5.4.6 Pulse inhibit, IMP
5.4.7 Act. value = Setpoint
5.4.8 Act. value = 0
5.5 Monitor Outputs
5.6 Digital frequency output X9 (Option)
6 Additional open-loop and closed-loop control functions
96
6.1 Chopper frequency 96
6.1.1 Automatic chopper frequency reduction 97
6.2 Automatic DC-injection brake 97
6.3 Slip compensation 97
6.4 S-shaped ramp generator characteristic 98
6.5 Limitation of the frequency setting range
98
6.6 Oscillation damping
98
6.7 Load-Change damping
98
7 Overload protections
7.1 Overload protection of the frequency controller
99
(1.t monitoring)
7.2 Overload protection of the motor
8 Display functions
8.1 Code set
8.2 Language
8.3 Display of actual valuesAct. value
8.4 Switch-on display
8.5 Identification
99
99
100
100
101
101
101
101
lalze
5