Maintenance...Messages
5-150
LTO
0x411 Small adaptors fitted? The 19 mm diameter adaptors
are required for the procedure
you have selected.
Confirm the message.
Fit the small adaptors.
0x412 Small adaptors fitted? The 17 mm diameter flat adap-
tors are required for the proce-
dure you have selected.
Confirm the message.
Fit the small flat adaptors.
0x413 Edging impossible: radius
too small.
The shape is smaller than the
smallest adaptor.
Confirm the message.
Remove the lens from the ed-
ging station.
0x414 A feeler fault has been de-
tected during feeling.
An irregularity has been de-
tected during lens feeling.
Confirm the message.
Restart the cycle and observe
the lens feeling process:
- If one of the tips is unclipped,
refit it.
- If not, proceed with the lens
feeling adjustment.
0x415 Bevel out of lens. The bevel is outside the lens in
at least one point.
Confirm the message.
Display the fault on the control
screen and proceed as required.
0x416 Retouch impossible. You have activated the retouch
control and the lens detected
does not match the parameters
of the lens you wish to retouch.
Confirm the message.
Remove the lens fitted on the
shafts.
Fit the lens you wish to retouch.
0x41A Lens too thin for grooving.
Do you want to continue?
A thickness of less than 1 mm
has been detected in at least
one point of the lens.
YES: The lens is edged with rim-
less finishing.
NO: The cycle is stopped. Remo-
ve the lens from the edging
station.
0x41B Lens too small. Feeling carried out 3 successive
times, 0.5 mm closer to the inte-
rior each time.
Lens too small or too off-cente-
red in comparison with the sha-
pe.
Confirm the message.
Remove the lens from the ed-
ging station.
0x41C Drill diameter > hole diame-
ter.
Do you want to drill?
The diameter of at least one
hole is smaller than the diameter
of the mill bit.
But the minimum drilling diame-
ter is equal to the bit diameter.
YES: The hole(s) will be drilled
with a minimum diameter equal
to that of the bit.
NO: the lens is not edged. Re-
move the lens from the edging
station.
0x506 Please remove lens to free
mill bit before acknowled-
ging this message.
A fault has occurred when the
mill bit was not in its housing.
The lens could be damaged.
Make sure that the machine is
switched off.
Free the lens from the mill bit
carefully.
Restart the machine.
0x508 Replacing the mill bit is
recommended.
Do you want to do it now?
At start-up, the machine records
total drilling time greater than 1
hr. Replacing the mill bit is
recommended.
YES: Change the mill bit (see
“Replacing the mill bit”,
page 102)
NO: You accept the risk of using
a worn mill bit. The risk of chip-
ping the lens is increased. The
message is displayed at each
machine start-up.
# Message title
Condition(s) for
display
Action(s)
To Next Page
