Maintenance...Messages
5-149
LTO
0x406 External safety-bevel will
not be made.
Do you want to continue?
External safety-bevel cannot be
made.
The lens is too thin and/or the
shape is too small.
YES: the lens is edged without
an external safety-bevel.
NO: the lens is not edged. Re-
move the lens from the edging
station.
0x407 Internal safety-bevel will not
be made.
Do you want to continue?
Internal safety-bevel cannot be
made.
The lens is too thin and/or the
shape is too small.
YES: the lens is edged without
an external safety-bevel.
NO: the lens is not edged. Re-
move the lens from the edging
station.
0x408 The groove will not be
made.
Do you want to continue?
The groove cannot be made.
The lens is too thin and/or the
shape is too small.
YES: the lens is edged without a
groove.
NO: the lens is not edged. Re-
move the lens from the edging
station.
0x409 The safety-bevels will not be
made.
Do you want to continue?
The safety-bevels cannot be
made.
The lens is too thin and/or the
shape is too small.
YES: the lens is edged without
the safety-bevels.
NO: the lens is not edged. Re-
move the lens from the edging
station.
0x40A External safety-bevel & gro-
ove will not be made.
Do you want to continue?
External safety-bevel and groo-
ve cannot be made.
The lens is too thin and/or the
shape is too small.
YES: the lens is edged without
an external safety-bevel or a
groove.
NO: the lens is not edged. Re-
move the lens from the edging
station.
0x40B Internal safety-bevel & gro-
ove will not be made.
Do you want to continue?
Internal safety-bevel and groo-
ve cannot be made.
The lens is too thin and/or the
shape is too small.
YES: the lens is edged without
an internal safety-bevel or a
groove.
NO: the lens is not edged. Re-
move the lens from the edging
station.
0x40C Safety-bevels and groove
will not be made.
Do you want to continue?
Safety-bevels and groove can-
not be made.
The lens is too thin and/or the
shape is too small.
YES: the lens is edged without
the safety-bevels or the groove.
NO: the lens is not edged. Re-
move the lens from the edging
station.
0x40D Lens too thick: edging im-
possible.
The lens thickness at the mea-
sured point is greater than 11
mm. The lens cannot be edged.
Confirm the message.
Remove the lens from the ed-
ging station.
0x40E Edging stopped: visor open. You have opened the visor du-
ring the edging cycle.
Check the lens and remove it
from the edging station.
Confirm the message.
0x40F Problem detected. Machine
re-initialisation.
A problem has been detected
during the cycle. The machine
must restart before continuing.
Confirm the message.
0x410 Lens too small. Do you want
to continue?
Lens too small or too off-cente-
red in comparison with the sha-
pe.
Y
ES: the lens is felt again 0.5
mm closer to the interior.
It can be re-felt 3 successive ti-
mes, 0.5 mm closer to the inte-
rior each time.
NO: Remove the lens from the
edging station.
# Message title
Condition(s) for
display
Action(s)
To Next Page
