Using your Edger...Usual procedure
3-55
LTO
3.2.8.1.1 NORMAL EDGING CYCLE SEQUENCE
Once you have started the edging cycle, the following steps follow automatically:
(except if the cycles are personalised)
Flow chart 3-1 : Edging cycle sequence
Note : The selection of the Manual finishing type (beveling, grooving) leads to a modification
of the normal sequence of the edging cycle.
emotion2 / perception2
Closing of the lens clamp shaft
Lens roughing
Lens finishing (Rimless or Bevel)
Lens polishing (if selected)
Lens safety-beveling (if selected)
Lens grooving (if selected)
Drilling of the lens (automatic, if a hole is
present)
To Next Page
