5-12
Application Manual CDA3000
5 Software functions
_76CI Current injection, section 6.1.4 (as from firmware V1.4)
760-CICN1 CDS1: Current injection reference value 1
763-CICN2 CDS2: Current injection reference
_77MP Magnetizing, section 5.5.14
770-MPCN1 CDS1: Magnetizing current
772-MPCN2 CDS2: Magnetizing current
774-MPT Magnetization time for SFC and FOR
_78SS Speed controller SFC, section 6.2.1
780-SSGF1 CDS1: Scaling of speed controller gain
781-SSG1 CDS1: Controller gain of encoder
782-SSTL1 CDS1: Speed controller lag time
783-SSTF1 CDS1: Filter time constant of speed estimate
784-SSGF2 CDS2: Scaling of speed controller gain
785-SSG2 CDS2: Controller gain of encoder
786-SSTL2 CDS2: Speed controller lag time
787-SSTF2 CDS2: Filter time constant of speed estimate
_80CC Current control, section 6.3.3
800-CCG Current controller gain
801_CCTLG Current controller lag time
802-CCTF Filter time constant for current measurement
803-VCSFC Correction factor of fault voltage characteristic SFC
804-CLIM1 CDS1: Maximum reference current for current control
805-CLIM2 CDS2: Maximum reference current for current control
_81CC Speed controller FOR, section 6.3.2
810-SCGF1 CDS1: Scaling of speed controller gain
811-SCG1 CDS1: Speed controller gain
812-SCTL1 CDS1: Speed controller lag time
813-SCTF1 CDS1: Jitter filter time constant
814-SCGF1 CDS2: Scaling of speed controller gain
815-SCG1 CDS2: Speed controller gain
Auto-tuning parameters
Used in control
mode
VFC SFC FOR
Table 5.6 Parameters changed during auto-tuning
To Next Page
Loading...
