REPAIR INSTRUCTIONS, PART 1
Page 175
10. Tighten the set screw of the extractor tool to
secure the bolt. Make sure that the set screw
is seated against the flat part of the extractor
bolt.
11. Place the extractor tool with the bolt into the
injector bore. Make sure the nut on the
spindle is backed off so that the threaded
end can be completely installed through the
copper sleeve tip. Hand tighten until the bolt
bottoms out in the sleeve.
223
Figure 223 — Extractor Tool Installation
Make sure the extractor bolt is threaded
completely into the copper sleeve before
attempting to remove it or the tip of the sleeve
may break off as it is removed.
12. Screw the injector sleeve removal tool,
9998253, completely into the injector sleeve
and then back it out 1/2 turn. Remove the
sleeve by turning the nut while holding the
threaded shaft of the removal tool.
224
Figure 224 — Removing Injector Sleeve
When the copper sleeve is removed, make sure
that the extractor bolt is extended at least one
thread beyond the copper sleeve. If not, make
sure that no part of the copper sleeve has broken
off.
Do not use air tools to remove copper sleeves, or
damage to the injector bore can result.
1. Injector Sleeve Remover
9998253
2. Injector Sleeve
To Next Page
Loading...
