Page 312
SPECIFICATIONS
Additional Top of Engine Components
Cylinder Head Plugs
Plug, M10 x 1.00 20 ±4 N•m (15 ±3 lb-ft)
Plug, M10 x 1.00, coated 10 ±2 N•m (7 ±1 lb-ft)
Plug, M14 x 1.50, coated 30 ±3 N•m (22 ±2 lb-ft)
Cylinder Head Connectors
Right side, coated 10 N•m (7 lb-ft)
Rocker Arm Components
Locknut, Valve Adjustment (Inlet and Exhaust) 38 ±4 N•m (28 ±3 lb-ft)
Jam Nut, Injector Adjustment 52 ±4 N•m (38 ±3 lb-ft)
Retainer Screw, Shim (Exhaust Yoke) 38 ±4 N•m (28 ±3 lb-ft)
Engine Brake
Attaching Screws, Control Valve 24 ±4 N•m (18 ±3 lb-ft)
Attaching Screws, Control Valve Mounting Plate 24 ±4 N•m (18 ±3 lb-ft)
Attaching Nut, Harness Lead (note lb-in) 1.8 ±0.3 N•m (16 ±3 lb-in)
Injector Yoke Screws
Important Note: Do NOT apply silicone sealant to new, coated screws.
Do NOT reuse M8 screws.
Step 1. 20 +5/−0 N•m (15 +4/−0 lb-ft)
Step 2. Angle tighten 180° ±5°
Step 3. Loosen the screws until the torque is 10–15 N•m (7–11 lb-ft).
Step 4. 20 +5/−0 N•m (15 +4/−0 lb-ft)
Step 5. Angle tighten 90° ±5°
To Next Page
Loading...
