SPECIFICATIONS
Page 313
MP7 ENGINE COMPONENTS — FRONT OF ENGINE
Crankshaft Damper
442
Figure 442 — Torque Sequence Screw Numbers — Damper to Crankshaft
Crankshaft Front Seal Cover
443
Figure 443 — Sealant Application Pattern — Cover to Block
Step 1. In the order indicated 40 ±4 N•m (30 ±3 lb-ft)
Step 2. In the order indicated 90 ±10 N•m (66 ±7 lb-ft)
Remove all old sealant before attempting to apply new sealant.
Apply a 2 mm (5/64 inch) bead of MACK approved sealant to the seal cover following the pattern (A) shown.
Attach the seal cover to the cylinder block within 20 minutes of applying the sealant.
To Next Page
Loading...
