SPECIFICATIONS
Page 325
Additional Right-Side Engine Components
Turbocharger
Heater, Inlet Air 24 ±4 N•m (18 ±3 lb-ft)
Attaching Nuts, Turbocharger to Exhaust Manifold 48 ±8 N•m (35 ±6 lb-ft)
Oil Supply Line 25 ±5 N•m (18 ±4 lb-ft)
Oil Drain Pipe 24 ±4 N•m (18 ±3 lb-ft)
Turbocharger SRA
Coolant Return Fitting 18 ±3 N•m (13 ±2 lb-ft)
Elbow (90°) Locking Nut 36 ±6 N•m (27 ±4 lb-ft)
Nut, Fitting (All) 16 ±3 N•m (12 ±2 lb-ft)
Attaching Screws, SRA to Turbocharger
Step 1. (note lb-in)
Step 2. (note lb-in)
3 N•m (26 lb-in)
11 N•m (97 lb-in)
Starter
Attaching Nuts 48 ±8 N•m (35 ±6 lb-ft)
Attaching Studs 17 ±2 N•m (13 ±1 lb-ft)
Control Wire Attaching Nut (note lb-in) 3 ±1 N•m (24 ±3 lb-in)
Power Cable Attaching Nut (M10) 18 ±2 N•m (13 ±1 lb-ft)
Oil Filter
Filter Housing Attaching Screws 24 ±4 N•m (18 ±3 lb-ft)
Oil Filter 25 ±5 N•m (18 ±4 lb-ft)
M6 Screws 10 ±2 N•m (7 ±1 lb-ft)
Pressure Relief Valve Attaching Screws (note lb-in) 10 ±2 N•m (89 ±18 lb-in)
Cooling Duct Cover
Oil Cooler Attaching Screws 27 ±4 N•m (20 ±3 lb-ft)
Plug, Cooling Duct Cover 24 ±4 N•m (18 ±3 lb-ft)
Cylinder Block Heater 10 ±2 N•m (7 ±1 lb-ft)
Water Drain Connector 40 ±4 N•m (30 ±3 lb-ft)
Fitting Jam Nut, 90° V-Nipple Elbow 60 ±6 N•m (44 ±4 lb-ft)
Nut, Coolant Hose 60 ±6 N•m (44 ±4 lb-ft)
Coolant Pipe
Upper Coolant Pipe Housing 24 ±4 N•m (18 ±3 lb-ft)
Coolant Pump Inlet Flange 24 ±4 N•m (18 ±3 lb-ft)
To Next Page
Loading...
