Installation and User Manual
10
2.
SAFETIES
2.1
General safety information
2.1.1
Reference European Community Directives
The P3UP has been designed and manufactured in accordance with the directives indicated on page 2.
The P3UP must be managed by a grinder type machine used to machine mechanical parts, in compliance
with the applicable safety standards in the user’s country in terms of machinery equipment
2.1.2
Product conformity
The P3UP described in this document has been designed and manufactured to be installed in an industrial
plant.
Any modification that alters the P3UP design and/or manufacturing specifications may only be
implemented by Marposs, who shall be responsible for certifying compliance with the safety
standards.
Therefore the modifications or maintenance interventions not set out in this document shall be
considered unauthorised.
Marposs declines all responsibility in case of any non-compliance with the above.
2.1.3
Selecting the operator
2.1.3.1 Definition of the operator
The R.E.S.S. 1.1.1 “Definitions” of attachment I of machinery directive 2006/42/EC, defines the operator as
the person or persons assigned to install, operate, adjust, clean, repair and move a machine or to repair it.
2.1.3.2 State of health of the operator/installer
The operator assigned to install the P3UP must be aware and responsible of the dangers that may be
generated during the installation of machining equipment.
To Next Page
Loading...
