marposs P3UP - 2.2 P3 UP Safety Information

Installation and User Manual
14
2.2 P3UP Safety information
2.2.1 Authorised and unauthorised usage.
2.2.1.1 Authorised usage
The P3UP has been designed and built to be installed on automatic machines such as grinders in order to
manage the Marposs measurement heads used for in-process part dimension controls.
[
N.B.
Any use that differs from the use described above is considered unintended.
Any modification altering the P3UP in terms of safety and risk prevention may only be made by
the Marposs, which will certify equipment compliance with safety standards.
Therefore modifications or maintenance interventions not set out in this technical document shall
be deemed unauthorised.
Marposs declines all responsibility in case of any non-compliance with the above.
2.2.1.2 Unauthorised usage
Do not use the P3UP:
1. in environments with the risk of explosion or fire;
2. in environments where contaminants such as acids, corrosive gases, salts etc. are present (see
para. 4.1.1.1 and 4.1.1.6;
3. In environments where the P3UP may be exposed to radiation such as microwaves, ultraviolet rays,
lasers, X rays, etc. - see para. 4.1.1.7
Never:
4. modify the original P3UP settings;
5. connect the P3UP to power supplies having specifications that differ from those described in this
manual;
6. Use components for uses not set out by Marposs.