Installation and User Manual
28
Figure 10: External dimensions diagram – Bracket version 2/2
N.B.
If necessary, a mounting bracket is available for the P3UP
Bracket mounting instructions:
1. Disconnect the power supply lead and the machine I/O cable in order to ensure that the unit is de-
energised.
2. Remove the plugs from the two M5 threaded holes positioned on the rear panel.
3. Secure the bracket using the two M5 x 6 screws (supplied): Do not use longer screws
4. Secure the bracket to the machine tool using the 6.5 mm holes.
To Next Page
Loading...
