172 CONTENTS
Figure 2: wxPropView - Sequencer Configuration Mode = On
2. Set the "Sequencer Feature Selector", if it is not already active (pink box, figure 3): "Sequencer Feature
Selector" = "ExposureTime" and "Sequencer Feature Enable" = "1".
3. Set the "Sequencer Feature Selector" for the duration counter (pink box, figure 4): "Sequencer Feature Se-
lector" = "CounterDuration" and "Sequencer Feature Enable" = "1".
4. Then, each sequencer set must be selected by the "Sequencer Set Selector" (orange box, figure 3): "←-
Sequencer Set Selector" = "0".
Figure 3: wxPropView - Sequencer set 0
MATRIX VISION GmbH
To Next Page
Loading...