MCCORMICK X60 Series - Area Worked; Counter Activation

68
Instruments and Programming
1.1.2 Area worked
IfthedownbuttonispushedtheAreaWorkedmenuisselected:
Thescreenshows:
Time-13:24
Areaunitsselected-Acres
Areaworked-28.3Acres
PTOmodecurrentlyselected-1000Rear
PTORPM-0
ThearrowindicatestheAreamenuisselected.Ifthecounterisoperating,thisarrow
willflashwhenthemenuisselected.Eachtimethemenuisselected,thecounter
willdisplay"AUTO"or"Man"(MANUAL)2secondslongbeforedisplayingtherelative
value.Theoperatoristhusinformedaboutthesettingsactuallyactive.(Seeselection)
Use:
-Thefirstscreenshotshowstheareaworkedintheunitspresetintheaccessorymenu.TheunitsareAcresorHectares.
-Onedecimalplacewillbeshownuntiltheamountofunitsreaches9999.9,atthispointthecounterwillshow10000+.
If99999isexceededthecounterwillreset.
-Countercanworkintwodifferentmodes.Modeselectionisavailableintoaccessorymenu(seeAutoFunctionSettings):
Manual Mode: when activated by the operator, the counter counts every time the tractors is moving (if
implement width has been previously defined) until the operator stops it.
Auto Mode: if implement width has been previously defined, the counter starts and stops to count auto-
matically when the tractor is moving and either the hitch is down or the Remote implement switch is on.

AutoandManualmodewillincrementthesamecountervalue.
CounterActivation:
-PushingtheMENUbuttonfor<2secsstarts/stopstheareacounter(onlyforManualmode)
-PushingtheMENUbuttonfor>2secswhencounterisvisualizedandnotactiveresetsthecounter.
-Ifpushedforlongerthan2secondswhenactivethecounterwillstop(onlyforManualmode).
-IftheUPorDOWNarrowsarepressedtochangethemenufunctionselectedwhenthecounterisactive,itwillcontinue
tocount.
-Toturnthedistancecounteroffafterexitingthemenutheoperatorwillhavetogobackintothisscreenandpressthe
menubutton(onlyforManualmode).
-Ifactiveatkey-offtheunitwillstartagaincountingatkey-on(onlyforManualmode).
Notes:
1)OnlyAreaworkedfunctionwillbeactivatedinmanual
2)Tocounttheareaworked,theimplementwidthhastobepreviouslydefined(AccessoriesMenu4).