60-12 Maintenance - 10 Service Hours or Daily VX30/VX50 Gen3/ECO50 Vacuum Systems
Hydraulic Fluid Level - Check
Clean hydraulic fluid is very important. Do not
s
pill dirt or contaminants into tank. Filter all
hydraulic fluid through a 10-micron filter
before adding it to the tank. Check hydraulic
fluid level.
Keep tank filled to sight glass/upper half of
sight gauge with required fluid. Refer to
“Lubricants,” page 70-1. Machine must be
level when checking.
Step 1: Remove fill ca
p (1).
Step 2: VX
30: Fill tank to approximately 1"
(2.5 cm) from top of tank.
VX50: Fill to upper
half of sight
gauge level (2).
Step 3: Install fill cap.
To Next Page
Loading...
