Medrad Intego - Managing Power States; Powering on the System

17
2 - System Basics
Managing Power States Powering On the System
WARNING: To avoid risk of electric shock, this equipment must only be
connected to a supply mains with protective earth.
CAUTION: DO NOT use the Intego™ PET Infusion System immediately after it
has been brought indoors from extreme outside temperatures. Condensation
may cause electrical damage to the system. Allow the Intego™ PET Infusion System
to stabilize at room temperature before use.
1. Plug the Intego™ PET Infusion System power cable into an AC outlet and move the
Power Switch to the On position.
2. Press and hold the ON/SHUTDOWN/STANDBY button until a beep sounds. The
Introduction screen will appear.