14
Medrad™ Intego™
PET Infusion System
Source Administration
Set (SAS) Components
1. Saline Spike – Inserted into the Saline Container.
2. Saline Tube – Section of tube that is placed along the SAS Track and into the Saline
Pump.
3. RP Tube – Section of tube from the Needle Cartridge to the Confluence that is placed in
the RP Pump.
4. Needle Cartridge – Contains the needles used to draw the RP into the SAS.
5. SAS Coil – Inserted into the Dose Calibrator. It holds the RP dose being measured by the
Dose Calibrator.
6. Pre-Coil Tube – Section of tube from the Confluence to the SAS Coil.
7. Post-Coil Tube – Section of tube from the SAS Coil to the T-Connector.
8. Waste Container – Collects any discarded fluid.
9. T-Connector – Union of Waste Tube, Patient Tube, and the Post-Coil Tube.
10. Waste Tube – Section of tube from the T-Connector to the Waste Container.
11. Patient Tube – Section of tube from the T-Connector to the Swabbable Valve.
12. Swabbable Valve – Enables aseptic connection between the SAS and PAS.
13. Saline Disconnect Luer – Disconnects the Saline Tube from the Saline Container.
14. Confluence – Union of RP Tube, Saline Tube, and Pre-Coil Tube.
To Next Page
Loading...
