Medrad Intego - Cleaning Guidelines

Medrad™ Intego™ PET Infusion System
82
Cleaning Guidelines CAUTION: DO NOT use strong cleaning agents and solvents. Warm water and a
mild soap solution are all that are required to clean the Intego™ PET Infusion System.
Allow all components to dry thoroughly before using.
CAUTION: DO NOT soak or immerse any part of the Intego™ PET Infusion
System or expose to excessive amounts of water or cleaning solutions while
cleaning. Avoid allowing any fluids to leak inside system components. Improper or
careless cleaning methods may result in equipment damage. Wipe components with
a gauze pad dampened with a mild soap and water solution.
NOTE: Follow facility guidelines for the clean-up of spilled radioactive pharmaceuticals.
NOTE: For all body fluid spills, follow institutional decontamination procedures. If fluid
has leaked inside any component of the Intego™ PET Infusion System, the
affected subassembly should be disassembled and cleaned by MEDRAD
personnel or returned to MEDRAD.
Cleaning Guidelines
Before beginning, disconnect the Intego™ PET Infusion System from AC power. If
necessary, remove the SAS and the Multi-Dose Vial from the system by following the
instructions outlined in the "Removing the Multi-dose Vial and SAS" section of the manual.
Equipment Cleaning
Guidelines
Cleaning Tools
Interior of the Shielded
Chamber.
Wipe clean and dry
thoroughly.
A soft cloth or paper towel dampened
with mild cleaning solution.
Exterior of the cart. Wipe clean and dry
thoroughly.
A soft cloth or paper towel dampened
with cleaning solution or warm water.
Touch screen. Wipe clean. A soft, non-abrasive cloth or paper
towel dampened with cleaning
solution.
Vial Shield. Wipe clean and dry
thoroughly. Ensure
the vial shield
exterior is free from
debris.
A soft cloth or paper towel dampened
with cleaning solution or warm water.
Needle Insertion Guide. Ensure that the
needle insertion
guide is free from
debris.
A soft cloth or paper towel dampened
with cleaning solution or warm water.