Microhard Systems IPN3G - Page 155

© Microhard Systems Inc. 155
5.0 AT Commands
AT+MPINS1
AT+MPINS2
AT+MPINS3
AT+MPINS4
Command Syntax
Sets initialization Strings. Carrier dependant.
AT+MPINS1=<initialization string>
AT+MPINS2=<initialization string>
AT+MPINS3=<initialization string>
AT+MPINS4=<initialization string>
Description
Example
Input:
AT+MPINS1=init-string <enter>
Response:
OK
AT+MWSIP
Command Syntax
Sets WAN Static IP. Do not set unless
specifically advised to do so by the carrier.
AT+MWSIP=<static IP address>
Description
Example
Input:
AT+MWSIP=0.0.0.0 <enter>
Response:
OK
AT+MURD
Command Syntax
Enable/Disable remote DNS. Enabled by
default, the IPn3G, will use the DNS server as
specified automatically by the service provider.
AT+MURD=<Mode>
Mode:
0 Disable
1 Enable
Description
Example
Input:
AT+MURD=1 <enter>
Response:
OK
The AT&W command
must be issued to save
changes!