Microhard Systems IPN3G - Page 158

© Microhard Systems Inc. 158
5.0 AT Commands
AT+MCOPS
Command Syntax
Enable or Disable COM1 serial port.
AT+MCOPS=<Mode>
Mode:
0 Disable
1 Enable
Description
Example
Input:
AT+MCOPS=1<enter>
Response:
OK
AT+MCOCM
Command Syntax
Sets COM1 serial port channel mode.
AT+MCOCM=<Mode>
Mode:
0 RS232
1 RS485
2 RS422
Description
Example
Input:
AT+MCOCM=0 <enter>
Response:
OK
AT+MCOBR
Command Syntax
Set COM1 port baud rate.
AT+MCOBR=<Baud Rate>
Baud Rate:
0 300
1 600
2 1200
3 2400
4 3600
5 4800
6 7200
7 9600
8 14400
9 19200
10 28800
11 38400
Description
Example
Input:
AT+MCOBR=7<enter>
Response:
OK
12 57600
13 115200
14 230400
15 460800
16 921600
The AT&W command
must be issued to save
changes!